Ok, many of you have seen the 510 custom I’ve begun. I took some progress shots along the way. This is them..
Cut lines marked out.
I think this is my neatest rivet drill out so far. I will drill for a screw later.
Open for business.
Bits n pieces.
DO NOT TRY THIS AT HOME! Because...
...I went with a hacksaw instead. If I had a Dremel I would use it. Father’s Day is a few months away yet so I will place an order..
Managed some neat sawing for a change and kept the edges attached while the center is through. Check out the off tampos!
Done!
To remove the rear window surround I just made a small nic at the base of the posts on the inside and flexed the frame out. It snapped off cleanly enough.
‘It’ll buff out”
Scored and snapped the ‘glass’.
Mock up shots. I’ll probably make the rear pillar more upright, not sure yet.
Thanks for checking it out.