I am thinking this is how I want to rig up my LED bar that’s coming, It will be part of a larger install of a bussman aux. electrical buss. Does this look right to you all? NOTE: the low beam jumper is this (at the bottom of the page) and basically just acts as a plug and play jumper into the low beam harness so I can use it as a relay trigger (in addition to a switch) so that the bar turns off when the low beams do (high beams stay on with low beams so I can use all 3 lights at once). Also, in regards to ground, is it best practice to ground to a common chassis, ground back to battery, or just ground to a good chassis ground? Also, I’ve read someplace that if you add a relay you should add additional grounding straps from the battery to the chassis...does that make sense to anyone?