Put a 1" shock spacers on the ZR2.
before
after
spacer is wayyyy up there. Wish I had my 18mm ratchet wrench on me. Standard wrench did fine, just took about 30 minutes to undo 3 nuts.
Drives the same, but an inch higher in the front. Helps level it even to the rear suspension. Inch is the most you can do without hurting the C/V joints.
That front bumper has to go...
That’s why I ordered this!!!! CBI offroad ZR2 front bumper with bar. Went with this one over the Relentless because this one has a gasket that goes on top between the body, and they make more stuff so better build quality?
Im not adding a winch, but will add two square yellow lights to use as fog lights / blind everyone (no I don’t do that)
Should be in sometime in January
Maybe some bigger tires when these need replacing ;D