Back story: My bedsides had rusted as all these trucks do, so I welded in new bed sides and got a new tailgate last fall hoping to get it painted before winter. Winter had other plans:
![Illustration for article titled Needed a break from the car](./agwafg01uu76thhnkgbl.jpg)
![Illustration for article titled Needed a break from the car](./w9cnbzaph5nqxtvkqda9.jpg)
![Illustration for article titled Needed a break from the car](./q8hzr2liza6tgj1jhqq8.jpg)
So I started into finishing the body work I didn’t get done last fall:
![Illustration for article titled Needed a break from the car](./px20cbr92lr2otqcasob.jpg)
![Illustration for article titled Needed a break from the car](./zjifrc5n5cp3goqqcft2.jpg)
Driver’s side all sanded out. Got the passenger side sanded as well. I have a high spot on the passenger side I have to smooth out yet, otherwise the sides are ready.
Then I proceeded to go to the tailgate and found a rusty mess from not getting it painted last winter. So I sanded the rust off, cleaned it up, and decided I was going to lay a protective coating on it. Thought I had some black laying around, turns out I didn’t. I did have a lot of random colors though, so this became my temporary tailgate:
![Illustration for article titled Needed a break from the car](./etaov7eiafrskqcwm0ml.jpg)
![Illustration for article titled Needed a break from the car](./hjf8keloxwjk7gmfehib.jpg)
I’ll sand it out and paint it back to factory when I do the rest of the truck.